Description:
Anti-freeze Heating Cable With 2m power cable and mini thermostat inside.The installation of the water pipe heating cable is convenient and you can install it by yourself. It is appropriate for the plastic and metal pipe.
Easy - Fit heating cable with insulating tape to the water pipe. Then only plug in the mains cord-READY
Safe - CE-approved, Injection molding production, water-proof grade IP68
Comfortable - Never thaw out water pipes again or carry heavy water buckets in winter. Suitable for all water pipes whatever plastic or copper
Trusty - The thermostat automatically switches the heating cable as soon as the water pipe drops below +3 degrees. Additionally an insulating tube can be used for maximum protection down to -45 degree.
Energy Saving - The water pipe heating cable has the energy-saving temperature controller. When the temperature reaches the critical range, it will start the protection pipe automatically.
Technical Information:
Supply Voltage: 230V, 50Hz
Rated Output Power: 16w/m
Enclosure Class: IP44/68
Surface Temperature: Max +65 °C
Minimum Permissible Installation Temperature: 45 °C
Minimum Bending Radius: 25mm
Power Code Length: 2 meters
Temperature Range: ON: 6±3°C -- OFF: 13±3°C
Features:
1. The heating cable can prevent the freeze of the pipe and enable water to flow normally below 0°C
2. Maintenance of the required temperature in pipes
3. The heating cable uses thermostat to save energy.
Thermostat –ON:6±3°C--OFF:13±3°C
4. Easy installation
5. Reliable operation
6. Residential, Commercial or industrial applications
7. Be suitable for use on plastic and metal water popes.
8. This system can be installed with confidence and with the assurance that it will operate for years.
Attention:
Do not cut the heating cable!
Do not install where it can be damaged by game animals. - protect against biting.
Basically do not use tie wrap by installation
Installation
1) First unwind the heating cable. The cable must never be connected to the power line when it is wound up.
2) If the cable is too inflexible because of low temperatures, unwind it and put it for some minutes into the
plug.
3) Afterwards you can pass the cable.
4) The area around the pipe where you want to connect it with the cable must be accessibly and
non-attached.
5) The heating cable can not be passed behind walls
6) Put the thermostat with the round black contact area tightly on the coolest point of the pipe and fix it with
insulating tape.
7) Finally put the whole cable on the pipe and fasten it every 30~60cm with insulating tape.
8) Attention: the cable must be fastening straight on the pipe
9) Now you can check if your cable works.
10) Afterwards insulate the water pipe and the heating cable with mineral rock wool or foam. Attention: never
use more than 13mm of this material to insulate.
11) In general the heating cable must be protected against mechanical damage or biting.
12) The heating cable can not be put into liquids.
13) Finally plug the cable into a 230V main plug
