TK PRODUCTS Jimny Short Type Stabilizer Link Stabilizer Link Jb23 Jb43 Jb64 Jb74

---------------------------------------------------------------------- 【Voltage Compatibility】 When using electrical appliances, please note that they are designed for Japanese voltage specifications (90-110V), so if you use them with a different voltage, it may cause a malfunction. 【Plug Type】 Our products use Japanese plug types (A or B type). Please use a conversion adapter if necessary. 【Important Note on Transformers and Adapters】 A transformer adjusts voltage to match your device’s requirements. A conversion adapter only changes the plug shape and does not adjust voltage. Using only a conversion adapter without a transformer may result in damage to the product. 【Liability】 We are not responsible for malfunctions or damages caused by improper use, such as operating the product without a transformer. ----------------------------------------------------------------------

[Compatible models] Jimny JB23-5 and later, JB43-4 and later, JB64, JB74 This stabilizer link is about 30mm shorter than the standard. This is a set for one vehicle, both left and right. [Compatible models] Jimny JB23-5 and later, JB43-4 and later JB64, JB74 It is possible to correct the angle of the stabilizer link of a lifted vehicle and make the stabilizer work efficiently and effectively. By attaching it to a lifted vehicle, the stabilizer starts working sooner than the standard. The stabilizer also works more strongly and suppresses roll. By shortening it, the clearance with the ground is wider and it is less likely to hit obstacles. Compatible with 20mm to 3 inch lift. For 20 to 40mm lift, install as is, for 2 inch lift, use in conjunction with a 10mm stabilizer extension block, and for 3 inch lift, use in conjunction with a 25mm stabilizer extension block. *For lifts of 2.5 inches or more, be sure to use with an extension block. If you use a leading arm that is longer than the standard arm, install it as is for a 2-inch up, and install it in combination with a 10mm stabilizer extension block for a 3-inch up. *The third image is a comparison with the genuine product, the fourth image is an example of the product installed, and the fifth image is a comparison of the genuine product. This is a Mars stabilizer link. [Notes] When combining with a long shock absorber, it is necessary to check that there are no interference parts. If it is not adjusted properly, the stabilizer will always be active, so please adjust the installation angle of the stabilizer link with a stabilizer extension block or something similar so that it is at the correct angle. It is a new product, but since it is an overseas product, we will open it and check that there are no defects in the product before shipping it.